I treated myself to a set of clamps that happened to be on quite a sale. You really can’t have too many clamps, and with only four until now, I was in no danger of that. But with a new set of 30, I needed to figure out where to put them.

Turns out they fit very conveniently behind a door in my shop, so I made a quick and simple rack for them. I drilled out evenly-spaced holes in a piece of plywood, making sure that they were spaced about the width of the widest point of the clamps. Then I took it to the table saw, cutting a slot from one edge to the holes I’d drilled out.

This board got glued and screwed to a backer-board, and some triangular pieces were glued and screwed to support the top part. After screwing the assembly to the wall and letting the glue dry, it was ready to be loaded up!